Transition Strip
Click here for Top Ten Discussions. CLICK HERE for Q & A Homepage
Receive Free Rental Owner Updates Email:  
MrLandlord Q & A
     
     
Transition Strip (by Steve [OH]) Jan 8, 2018 6:20 AM
       Transition Strip (by plenty [MO]) Jan 8, 2018 6:32 AM
       Transition Strip (by Vee [OH]) Jan 8, 2018 7:08 AM
       Transition Strip (by RR78 [VA]) Jan 8, 2018 8:13 AM
       Transition Strip (by RR78 [VA]) Jan 8, 2018 8:18 AM
       Transition Strip (by Robert,Ontario.Can [ON]) Jan 8, 2018 9:20 AM

Click here to reply to this discussion.
Click Here to send this discussion to a friend

Transition Strip (by Steve [OH]) Posted on: Jan 8, 2018 6:20 AM
Message:

I have a 3/4" drop going from a bathroom floor to a hallway. I can't find a transition strip that works. Need wisdom here. Thank you. --75.187.xx.xx




Transition Strip (by plenty [MO]) Posted on: Jan 8, 2018 6:32 AM
Message:

we milled one out of wood.

look in the section of HomeD/Lowes for transition strips for clicky hardwood floors. --173.108.xxx.xxx




Transition Strip (by Vee [OH]) Posted on: Jan 8, 2018 7:08 AM
Message:

I have used the one that snaps into the plastic clip mounted on the floor, just added a strip of door trim to smooth out the bump - glue on with construction adhesive. --76.188.xxx.xx




Transition Strip (by RR78 [VA]) Posted on: Jan 8, 2018 8:13 AM
Message:

WE would just make one in a few minutes out of oak with a table saw and router.

But like plenty(mo) said look at box store by the laminate and hardwood flooring ones.

Should be able to get something close. Make have to still add a piece of of the shelf oak molding under one side.

Of course even with a hand saw. Could always just get a piece of 3/4" oak or PVC board. Do a 45 degree cut on one side. Then the cheap metal threshold strip on top of this.

By the oak lumber they sell 3 ft pieces of oak 1/4' , 1/2" and 3/4". Should be able to add one of these to a pre made strip to work. --73.177.xxx.xx




Transition Strip (by RR78 [VA]) Posted on: Jan 8, 2018 8:18 AM
Message:

Should have added. Then wood should step down so wider than the metal strip. Can even use 3 pieces of 1/4" stepping down to each one so more of a taper. --73.177.xxx.xx




Transition Strip (by Robert,Ontario.Can [ON]) Posted on: Jan 8, 2018 9:20 AM
Message:

Go into the website to Schluter products where there are many different types of transition fittings for different types of flooring. --147.194.xxx.xxx



Click Here to send this discussion to a friend
Report discussion to Webmaster


Reply:
Subject: RE: Transition Strip
Your Name:
Your State:

Message:
Transition Strip
Would you like to be notified via email when somebody replies to this thread?
If so, you must include your valid email address here. Do not add your address more than once per thread/subject. By entering your email address here, you agree to receive notification from Mrlandlord.com every time anyone replies to "this" thread. You will receive response notifications for up to one week following the original post. Your email address will not be visible to readers.
Email Address: